EK Water Blocks 3831109815380 Handbuch

Stöbern Sie online oder laden Sie Handbuch nach Computer Flüssigkeitskühlung EK Water Blocks 3831109815380 herunter. EK Water Blocks 3831109815380 Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
All disclosures, notices and warranty conditions are being written on www.ekwb.com Released on 25
th
of January, 2012.
Installation and mounting manuals for EK-MOSFET ASUS X99 water block:
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability whatsoever,
expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before installation of this product
please read any important notice, disclosure and warranty conditions printed on the back of the box and on EKWB home page.
EKWB recommends using EK -PSC fittings which require a small amount of force to screw them in; otherwise fittings might break or damage your block . These fittings do not need to be tightened with much
force because the liquid seal is made using rubber gaskets . EKWB does not recommend use of distilled water only in mixed metals loops, thus use of corrosive inhibitors is highly recommended.
STEP 1: GENERAL INFORMATION. Sample picture of ASUS X99 motherboard.
STEP 2: PREPARING YOUR MOTHERBOARD
1. REMOVING STOCK COOLER. Remove all eight (8) screws pins holding the
MOSFET heat-sink assembly. MOSFET heat sink as well as stock backplate should be
removed.
2. CUTTING THERMAL PADS. Your block comes with two precut thermal pads type
A: 0.5mm (100x16mm) and 1mm (100x16mm) , which have to be trimmed and placed
on MOSFET chips. EK recommends using small drops of electrically non-conductive (for
example: Arctic Cooling MX-2 or MX-4 ™) thermal grease on each phase regulator
(that is being covered wit h thermal pad; see picture below) in order to even further
improve the thermal performance of the water block.
STEP 3: PREPARING YOUR WATERBLOCK
PLACING WATERBLOCK ON MOTHERBOARD. Place waterblock on VRM section of
the motherboard’s circuit board as shown on picture below:
ATTACHING WATERBLOCK/BACKPLATE ON MOTHERBOARD. When waterblock is
safely placed on motherboard, please align the openings and fasten the waterblock to
factory backplate using the enclosed M3x10 DIN7991 screws to the motherboard’s
circuit board. It is recommended that you check for unwanted contacts before powering
up the system.
REQUIRED TOOLS AND MOUNTING SCREWS:
scissors philips screwdriver 2x screws M3x10 DIN7991
Thermal pad A 0,5mm
Thermal pad A 1mm
EK-MOSFET ASUS X99
Factory backplate
Factory glued washer
CSQ Fittings
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1

All disclosures, notices and warranty conditions are being written on www.ekwb.com Released on 25th of January, 2012. Inst

Kommentare zu diesen Handbüchern

Keine Kommentare