EK Water Blocks EK-UNI Holder 50/70 Handbuch

Stöbern Sie online oder laden Sie Handbuch nach Montagesätze EK Water Blocks EK-UNI Holder 50/70 herunter. EK Water Blocks EK-UNI Holder 50/70 Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Installation and mounting manual for EK-UNI Holders 50/70
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com
for updates.
Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the
liquid seal is made using o-rings.
STEP 1: GENERAL INFORMATION. Sam
p
le
p
icture of EK-UNI Holders 50/70
EKWB presents you new UNI holders that will ease up and add new installing dimensions to your PC case.
STEP 2: ATTACHING UNI HOLDERS TO PC CASE STEP 3: ATTACHING RESERVOIR HOLDERS ONTO UNI HOLDERS
Please look at sample picture where a UNI holder can be placed.
You can install holders on 5,25” Bay cage with enclosed M4 screws and install
reservoir holders on them.
STEP 4: ATTACHING RESERVOIR TO RES HOLDERS
Afterwards install reservoir upon your wishes. An oval holes of UNI Holders makes it super adjustable. Please be very careful if you posses acrylic holders as they
are prone to cracking. EKWB recommends attaching fittings/barbs…. prior to attaching reservoir onto holders, thus avoid putting additional stress on holders. By
all means also consider manufacturers instructions for reservoir treatment and filling.
REQUIRED TOOLS AND MOUNTING SCREWS:
Pliers Phillips screwdriver 4 M4x10 DIN7985 4 PVC washers 4 M4 nuts
PleasescrewinadequateRESholderscrew
andsecureitfirmlyindesiredposition.
PleasescrewinM4screwsandsecure
themwithwasherandnutontheother
side(indescribedsequence).
Alldisclosures,noticesandwarrantyconditionsarebeingwrittenonthebackofthebox. Releasedon4
th
ofMarch,2010.
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1

Installation and mounting manual for EK-UNI Holders 50/70 This product is intended for installation only by expert users. Please consult with a quali

Kommentare zu diesen Handbüchern

Keine Kommentare