EK Water Blocks EK-DCP 2.2 X-RES Handbuch PDF herunterladen

Revision 1.0. Released on 19

of February, 2013.

Installation and mounting manual for EK-DCP 2.2 X-RES Reservoir

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

1. Please carefully read the manual before through before beginning with the installation process!

2. The EK High Flow and EK-PSC or EK-CSQ type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.

3. The use of quality, market proved corrosion inhibiting coolants is strongly recommended for any liquid cooling system.

GENERAL INFORMATION. Sample picture of exploded EK-DCP 2.2 X-RES

STEP 1: PREPARING THE PUMP

Unscrew original M3 screws with Philips head screwdriver

and store them in a safe place. These screws will not be

needed any more.

STEP 2: PREPARING THE PUMP CONTINUED

STEP 3: CONNECTING THE PUMP AND RESERVOIR

Use four enclosed M3x16 DIN 7991 countersunk screws and attach

interconnection metal plate to the pump with enclosed Allen key 2mm.

ATTENTION!

Pay special attention to

orientation of the

interconnection metal plate.

The screws head must be

aligned (flushed) with the

metal plate.

In order to connect the reservoir and

the pump please follow these steps:

1) Install the provided gasket (o-

ring) into the milled groove as

shown on the picture below.

Failing to do this will cause

serious leakage.

2) Use four enclosed M3x8 DIN

7991 (countersunk) screws and

attach pump to the reservoir

with enclosed Allen key 2mm.

CAUTION:

Be extremely careful not to overtighten the M3

screw. Doing this may strip the thread and

render product useless.

TROUBLESHOOTING:

- If the threaded holes do not align

please re-check STEP 2 in the

manual.

- If the screw head does not

align (flush) with the metal

plate please re-check STEP 2 in

manual.

O-ring

M3x8

screw

1 2

Inhaltsverzeichnis

Seite 1 - ATTENTION!

Revision 1.0. Released on 19th of February, 2013. Installation and mounting manual for EK-DCP 2.2 X-RES Reservoir This product is i

Seite 2 - Water out

Revision 1.0. Released on 19th of February, 2013. STEP 4: INSTALLING THE MOUNTING PLATE: STEP 5: FINISHING THE INSTALLATION Screw i

Kommentare zu diesen Handbüchern

Keine Kommentare

EK Water Blocks EK-DCP 2.2 X-RES Handbuch

Stöbern Sie online oder laden Sie Handbuch nach Hardware-Kühlungszubehör EK Water Blocks EK-DCP 2.2 X-RES herunter. EK Water Blocks EK-DCP 2.2 X-RES Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware-Kühlungszubehör EK Water Blocks EK-DCP 2.2 X-RES